Sony RM-V21UNIVERSAL TV REMOTE CONTROLLER SETTING THE CODE

Sony RM-V21UNIVERSAL TV

REMOTE CONTROLLER SETTING THE CODE

To program in you first set the slide switch

to the component you want to set up.

• Press and release the SET button.       
• Press and release the code number.    
• Press and release the ENTER button.

 Checking if the code number works:                      

1.Power on the component.                                   

2.Aim the Remote Commander at the component

and press the POWER button. The component

should power off

3.When the component powers off, press the       

POWER button again to turn the component

back on. Then check that the Commander is

     operating the other functions of your component.

4.If the Commander does not seem to be working,

  try repeating the setup procedure with the next

code listed.

If the code numbers listed for the component do not seem to

 be working properly, you will need to search for the correct

code by completing the following procedure:

1.Power on the component that you would like

 to operate.

2.Set the slide switch on the Remote                

  Commander tothe position of the component

 that you want to set up.

3.Press and release the SET button.                  

     Press and release the CH+ button. Then press

and release the POWER button.

4.Repeat step 4 until your component powers off.

 Pressing CH+ and POWER repeatedly will try

every available code until the correct one is

found. Be patient as you do this;

.it may take 50 or 60 tries until the correct

code number is located.

5.When the component powers off, press           

and release the ENT button to store the

 code number in the Commander's memory.

6.Check that the Commander is operating the    

other functions of your component.

.Before you set up your commander to operate components on positions AV1 and AV2, you must first define the type of component you want to use at these positions.

1.Set the slide switch to AV1 or AV2.

2.Press and release the SET button    

3.Enter one of the codes from the     

 table below based on the type of

 component you are setting up.